Yanmar 6LY3 series Service Manual page 347

Troubleshooting by DTC Fault Codes
12/05
DTC Fault Code
DTC / FMI
1. Engine running
2. Crank speed detects 0 rpm when the starter is activated (key position at START) or
crank speed suddenly goes to 0 rpm while the engine is running.
P0335/4
3. 1 second
4. PWR REDUCTION, CHECK ENGINE on the TELEFLEX display
Fail Mode
Limited Operation
Fail Release
Limited Operation Release
Remarks
Fault
DTC / FMI
1.
P0335/4 2.
3.
Troubleshooting Procedure
1. Check if the starter is turning.
2. Check the wire harness.
3. Check the connectors and terminals.
4. Check the state of the speed sensor attachment
(dust, e.g.).
5. Check the sensor output signal.
6LY3 Service Manual
1. Condition, 2. Fault, 3. Time to Detect, 4. Display
Engine will keep controlling the engine speed with the cam signal.
(ECU uses crank speed as normal condition.)
Engine cannot control the injection timer and have the failure code of the injection timer control
with the injection timing fully retarded.
Maximum engine speed is limited to 1800 rpm.
Yes
When the difference between the cam and crank speed is within 15 rpm
Yes
After the fault has been cleared and also when the throttle position is at low idle position. If a
higher idle position is selected with the control head, limited operation status is not released.
White smoke or black smoke may increase more than usual because of the failure code of the
injection timing control. This error is also detected when the key position is in START and the
gear is in neutral but the starter is not running (when no battery cable is connected to starter).
Crank speed sensor wire harness open or shorted
Poor connection to the crank speed sensor connector
Bad flywheel condition
© 2007 Yanmar Marine International
TROUBLESHOOTING
Probable Cause
Check Point
Crank speed sensor
Starter
Wire harness
13-57