List Of Dtc (Diagnostic Trouble Codes); Tfx Diagnostic Screen Display Procedure 3 - Yanmar 6LY3 series Service Manual

TROUBLESHOOTING

List of DTC (Diagnostic Trouble Codes)

TFX Diagnostic Screen Display Procedure 3

Figure 13-8
i5601E Digital Display Alarms/Engine Diagnostic Codes
MAIN MENU
ALARMs / DIAGs
MONITOR SETTINGS
CALIBRATION
FACTORY SETTINGS
Password Protected
Buttons
Down Arrow moves menu selection down
Up Arrow moves menu selection up
Right Arrow acts on current menu item
Back Moves back to previous menu
BACK
Engine Alarms/Diagnostic Codes
The ALARMs / DIAGs Screen Menu allows user to go to the Alarm or Diag Code Screen. This is very useful
in the HOT KEY Mode, as a dedicated hot key is not required to view these screens. Use can hold Right most
key down go into the menu mode and then via this menu access the desired screen.
This information is also shown on the YDT.
Fault Code: Active DTC
Fault Code: Logged DTC
13-30
Performs the function indicated by a pop-up menu,
if present.
With no pop-up menu showing, briefly press to
display the Lighting & Contrast menu.
With no pop-up menu showing, press and HOLD
to display the MAIN MENU.
Figure 13-8
© 2007 Yanmar Marine International
Troubleshooting by DTC Fault Codes
Engine Alarms
The Alarm Screen will display the status of 20 defined alarms. A
flashing black background indicates unacknowledged alarm; a solid
black background indicates an acknowledged still in alarm state
status.
Engine Diagnostic Codes
This screen displays the diagnostic code information. The title bar
indicates the number of diagnostic items.
Maintenance Warning
Based on startup issues, the maintenance timer will activate between 50 and 60 hours of operation. A maintenance
warning will be displayed on the digital display screen. To acknowledge this warning, press and hold the #5
(right most) button on the i5601E digital display for a few seconds until the main menu is displayed. Use the
down arrow button to move the cursor to "Calibration." Press the right arrow button, then go to "User Setting"
menu. The arrow should be at the "Reset Maint. Time" selection. Press the right arrow key to reset. The warning
will go away. After an additional 250 hours of operation the maintenance warning will be displayed again, and
every 250 hours thereafter. This a reminder that periodic maintenance must be performed at these intervals.
6LY3 Service Manual
0006317