Long-Term Storage - Yanmar 6LY3 series Service Manual

Hide thumbs Also See for 6LY3 series:
Table of Contents

Advertisement

Periodic Maintenance Procedures
12/05

Long-Term Storage

Observe the following instructions when the engine
is to be stored for a long period of time:
1. Drain seawater in the cold season or before the
long-term storage. NOTICE: NEVER drain
coolant in the cold season or before the
long-term storage. Failure to add antifreeze can
cause major damage to the engine.
2. Clean the engine.
3. Perform the nearest periodic inspection before
storage.
4. Completely drain or completely fill the fuel tank
to prevent condensation in the fuel tank.
5. Disconnect the battery cable from the
negative (-) battery terminal.
6. Cover the silencer and electric parts with a
waterproof cover to prevent water and dirt from
entering.
6LY3 Service Manual
7. Select a well-ventilated location without
moisture and dust for storage.
8. Recharge battery once a month during storage
to compensate for self-discharge.
9. When storing an engine for a long time, run the
engine periodically, according to the following
procedure, because rust inside the engine, the
rack agglutination of the fuel pump and so on
are likely to occur.
(a) Replace the engine oil and the filter with new
(b) Fill fuel tank if the diesel fuel was removed,
(c) Confirm that there is coolant in the engine.
(d) Operate the engine at idle speed for about
© 2007 Yanmar Marine International
PERIODIC MAINTENANCE
ones before running the engine (See
Replace the Engine Oil and Engine Oil Filter
on page 4-22).
and bleed the fuel system.
5 minutes. Repeat monthly, if possible.
4-33

Advertisement

Table of Contents
loading

Table of Contents