Tighten the light down using a ½" wrench and a
Solder the red wire into the positive wire for the tail light circuit.
Solder the black wire into the ground circuit.
Cover any soldered joint with heat shrink, or electrical tape and repeat for the other light.
Make sure the lights are aimed correctly and illuminate the whole plate, then tighten if necessary.
Diffuser
Rivet tool,
3
/
" Hex key, ½" socket and ratchet
16
Secondary Body fasteners
Remount the Rear Diffuser using
3
/
" Hex key.
16
3
/
" rivets along with the spacers and bolts.
16
677
www.factoryfive.com
508-291-3443