Hazard Switch; Power Window Switches; Shifter Boot, Ring And Knob - Factory Five Racing GTM Supercar Assembly Manual

Hazard switch


¾" hole saw, round file

Dash and components
Decide where you would like to locate the switches.
Drill ¾" holes in the center console.
Use a round file to open the holes up slightly so the switches will fit.
Insert the switches in the Center Console.
Connect the switch wires.
1 – Connect to Hazard light wire (Brown 951).
2 - +12 volts
4 - Ground

Power window switches

Use the switch retaining ring and a marker to mark the desired location of the power window switches on
the center consule.
Cut the hole for the switch retaining ring.
Press the window switch retainer into the console.
Connect the wiring to the window switches.
Install the FFR Ignition Switch (unless you chose to mount it in another location other than on the console
trim plate).

Shifter boot, ring and knob

Place the shifter ring in place to determine how close to the hole you need to drill the screw holes.
Use the ring as a template to mark the console for the shifter ring screws.
Drill four ⅛" holes through the center console.
Slide the shifter boot over the shifter handle.
Place the shifter boot trim ring over the boot and align the holes in the boot with the holes in the ring.
Screw the shifter ring into the console
Install the shifter knob.
696
www.factoryfive.com 508-291-3443