GTM A/C Hose
Heater & A/C hose kit
Rivnut tool, Wire cutters, Wire crimpers, 4 mm Hex key,
kit
Installation Instructions
Refer to the manufacturers directions (See Appendices E, F) on routing the hoses for the A/C
system. Before installing any of the lines, be sure that the supplied O-rings are in place and will
give the proper seal.
Perform an inventory of all the parts included with the kit using the Vintage Air pack lists.
Install the two hard lines on the upper ports on the Evaporator unit according to the Vintage Air
diagrams. If the Evaporator unit is bolted in position, it may help to unbolt the unit and move it into a
position where you can tighten the hard lines in place. Leave the unit unbolted.
746
www.factoryfive.com
508-291-3443
25
/
" drill bit, Drill, 134a charge and oil
64