Ethernet Setup - Datamax H Class Operator's Manual

Ethernet Setup

The Print Server makes IP requests at power-up, so before making a network connection to
the printer consider how your IP Addressing needs to be assigned. The IP Addressing of the
Internal Ethernet Print Server can be configured in one of two ways:
> Using a static IP Address; or,
> Using IP Discovery (DHCP, BootP, or RARP).
Proceed according to your desired addressing method:
Note: At factory default settings IP DISCOVERY is DISABLED.
•
Configuration Using a Static IP Address:To use a static IP Address follow the steps
below:
1. Without connecting the Ethernet cable, turn ON the printer.
2. Verify the printer is in READY MODE then press the MENU Button.
3. Using the NAVIGATION Buttons, scroll to COMMUNICATIONS > NIC ADAPTER >
IP ADDRESS.
4. Use the UP and DOWN Buttons to increment or decrement each numeric value and
the RIGHT button to move to the cursor to the next digit. After all fields have been
input, press the ENTER Key to save the IP Address.
5. Scroll to SUBNET MASK and set the address in the same manner as the IP
ADDRESS.
6. Scroll to GATEWAY and set the address in the same manner as the IP ADDRESS.
7. If needed, you may set your SNMPTRAP DESTINATION address in the same
manner as the IP ADDRESS or use the HTML pages.
11