Printer Setup Mode - Button Functions - Datamax DMX E E-4204 Operator's Manual

4.4 Printer Setup Mode - Button Functions

In 'Printer Setup' mode, the buttons control the setting of the printer's
operational items such as media settings, communications, and options as
detailed below.
Notes: It is recommended that the Printer Setup Mode not be entered while
in Peel Mode or with the optional Present Sensor enabled.
Depending on label size this can cause unpredictable results.
Printer and cutter faults are disabled during
but can still occur while printing "test" labels.
If at any time you wish to discard your changes and revert back to
the previous values, simply turn off power to the printer.
If you wish to restore Factory Defaults see Section 5.7.
To change Printer Setup:
F1
(Press and hold during power-up until the Paused Light turns off)
Printer Setup Mode
F1 Prints the 'Printer Setup Menu List', see section 4.4.1
(
)
Press and
F2
Feeds one label for "test"
Release
(
Press and hold to advance to the desired menu
F2
item by counting the number of Fault Light flashes
F3 Prints the 'Test Label' for "test"
Saves the current values
+ F3
F1
and resumes
Printer Setup Procedure
F1 Increments item's value
(
)
Press and
F2
Selects the next menu item
Release
(
)
Press and
"Direct Select" menu item
F2
Hold
F3 Decrements item's value
Accepts the current
F1 + F3
values for "test"
E-4203/E-4204/E-4304
Normal Mode
(Current Item and Value is printed)
(e.g., 7 Fault Light flashes = Baud Rate,
menu item #7; see Section 4.4.3)
,
)
21