Datamax H Class Operator's Manual page 69

IMAGING Determines the process used to format labels, a selection that can affect
MODE throughput and the accuracy of time-stamping, where:
MULTIPLE Images multiple labels as memory permits, achieving the fastest throughput.
LABEL If time-stamping labels, however, the indicated time will reflect the moment
of imaging rather than the actual print time. (Default Setting)
SINGLE Images the next label only after the previous label has been successfully
LABEL printed, providing the most accurate time-stamping but slowing throughput.
PAUSE MODE Allows for the controlled, user-interactive, printing of labels, where:
ENABLED Requires the user to press the PAUSE Key to output each label.
DISABLED Labels are printed without pausing. (Default Setting)
PEEL MODE Allows the printer to wait until the GPIO Start of Print signal is received (via
the optional GPIO Port) to feed a label, where:
ENABLED Inhibits the feed function until the GPIO Start of Print signal is received.
DISABLED Feeds the label regardless of the GPIO Start of Print signal. (Default Setting)
SECURITY Allows all or part of the User Interface to be password-protected and for that
password to be modified:
SELECT Allows a four-digit password to be set for specific User Interface areas,
SECURITY where:
MENU AND Sets a password requirement for all menu areas.
TEST
SECURE Sets a password requirement for the User and Advanced menus.
MENU
DISABLED No password is required for access. (Default Setting)
MODIFY Modifies the four-digit password required for User Interface access when
PASSWORD security is enabled. To modify the password, select each digit using the UP
and DOWN Buttons, use the RIGHT Button to shift the cursor position, and
press the ENTER Key to input the code. You will be prompted to confirm the
new password by entering the same numeric code again. Afterward, exit the
menu and, at the SAVE CHANGES prompt, select YES to proceed with the
password (or NO to discard the changes).
Note: To be activated, the password must initially be set to a value other than the default
setting (0000).
UNITS OF Sets the measurement standard used in the printer's database, where:
MEASURE
IMPERIAL Gives length and counter information in inches. (Default Setting)
METRIC Gives length information in millimeters and counter information in
centimeters.
61