Boot Loader Downloads - Datamax H Class Operator's Manual

Boot Loader Downloads

Available updates for the Boot Loader program can be found at ftp://ftp.datamaxcorp.com.
Before performing this update, identify the printer's current Boot Loader version by printing a
Configuration Label and comparing the installed version to those available from the FTP site.
Download the desired version onto your computer's hard drive then follow the steps below to
update the Boot Loader program:
If power is lost while 'Upgrading Software' is displayed, the printer
will become non-functional; it must then be returned to the factory
for programming, or have its main logic board replaced.
Step Displayed
Message
1. READY
2. UPGRADING
SOFTWARE
Boot Loader Update Procedure
Operator Action
Using the DOS copy
command (where
'filename' is the
program to be loaded
and 'lpt1' is the
selected interface
port), enter the
following:
copy filename lpt1:
No action required.
103
Comments
If Security has been enabled, disable
the feature before proceeding.
As an example, this would be entered
as:
copy boottb~1.bs lpt1
(Where 'lpt1' is the host computer's
output port; however, your selection
can differ to include a serial or other
port, as equipped.)
The Receiving Data Indicator will
appear as data is received.
The new program is being stored and
verified.