Datamax H Class Operator's Manual page 61

UHF SETTINGS Sets UHF tag parameters:
*
TAG TYPE Sets the tag type:
TAG DATA Sets the tag data size:
SIZE
POWER
ADJUST
KILL CODE
ACCESS CODE
GEN 2 LOCK Sets the lock level: NONE, PERMALOCK, PWD-READ/WRITE, and BOTH
ACTION
LOCK AFTER
WRITE *
ENABLED
DISABLED
RETRY Sets the number of retry attempts (0 - 9), where:
ATTEMPTS *
3 Is the Default Setting.
PERFORM Automatically establishes the tag to transducer distance setting and nominal RFID
CALIBRATION * power requirements.
SET DEFAULTS Returns the RFID option settings to the factory default values.
*
GPIO PORT Configures the General Purpose Input / Output card to allow the printer to work in
concert with external devices, as follows:
GPIO DEVICE Sets the GPIO option to work with a specific type of device, where:
DISABLED Disables the GPIO Port.
APPLICATOR Enables the GPIO to work with a label applicator.
BARCODE Enables the GPIO work with a bar code verifier.
VERIFIER
START OF Selects the type of input signal needed to initiate the Start of Print (SOP) process,
PRINT * where:
LOW PULSE A low incoming pulse (approximately 30 milliseconds long) will trigger the SOP.
HIGH PULSE A high incoming pulse (approximately 30 milliseconds long) will trigger the SOP.
ACTIVE LOW SOP signal must go 'low' for at least 50 milliseconds to initiate printing.
ACTIVE HIGH SOP signal must go 'low' for at least 50 milliseconds to initiate printing.
EDGE An edge transition triggers SOP.
EPC 0
EPC 0+ MATRICS
EPC 0+ IMPINJ
EPC 1
UCODE EPC 1.19
EM 4022/1222
GEN 2
96-BIT
64-BIT
B3 B2 B1 B0
00 00 00 00
B3 B2 B1 B0
00 00 00 00
53