2.2.2
Connecting an Interface Cable
The printer can be interfaced to a host device via the Ethernet, USB or optional serial port.
Following power-up (or after inactivity), interface port selection occurs automatically upon
detection of valid data.
•
To change an active port immediately, cycle the power OFF and ON.
Ethernet Connection
The Ethernet interface supports several menu-selectable modes. Depending on the length, the
cable should be Category / Type 3 or better.
USB Connection
The USB interface connection may differ slightly depending upon the operating system and
hardware configuration of the host computer.
Optional Serial Connection
The serial interface supports RS-232C communications RS-232C cabling configurations via
standard a null modem cable.
7