Linux Lprng - Xerox WorkCentre 3215NI User Manual

22. To allow access to the printer, edit the /etc/hosts table to list the client system.
23. Edit and create the /etc/hosts.lpd file to list the client system.
Dynamic Addressing
Procedure
Follow the steps in Configure Dynamic IPv4 Addressing at the
Important: Highlight BOOTP in step 6.
Create the Print Queue
Follow the steps to Create the Print

Linux LPRng

Static Addressing
Information Checklist
Before starting ensure that the following item is available and/or the task has been performed:
• Linux operating system that supports PrintTool.
Procedure
Follow the steps in Configure Static IPv4 Addressing using the Machine User
this page.
Create the Print Queue
1. Open the LPRngTool from the Linux Client.
2. Select Add.
3. In the Names area, enter a name for your print queue.
4. The spool directory is the directory where print jobs are stored and is a subdirectory of
/var/spool/lpd. Add the name of the print queue to the end of the subdirectory path.
5. In the Hostname/IP of Printer area, enter the hostname or IP Address of the Xerox machine.
6. Select OK.
7. Select Exit to close the program.
8. To allow access to the printer, edit the /etc/hosts table to list the client system.
9. Edit and create the /etc/hosts.lpd file to list the client system.
Queue.
Network Installation: Linux CUPS
Machine, then return to this page.
Interface, then return to
Xerox® WorkCentre® 3215/3225 49
User Guide