Planet VDR-300NU User Manual page 58

On this page, you are allowed to configure the settings of the 3G USB modem.
Object
Enable USB
Modem
User Name
Password
Authentication
Method
APN
Dial Number
Idle time (in sec.)
Dial on demand
Dial Delay (in
sec.)
Default WAN
Connection Select
WAN back
mechanism
After finishing setting, click the Apply/Save button to save the settings.
You may also click the Auto Setting button to automatically configure the 3G connection.
After clicking the Apply/Save button, the following page appears.
Description
If you want to access the Internet through the 3G network card, you
must enable the USB modem.
Username provided by your 3G ISP.
Password provided by your 3G ISP.
Select a proper authentication method in the drop- down list. You can
select Auto, PAP, CHAP, or MSCHAP.
APN (Access Point Name) is used to identify the service type. Enter the
APN provided by your 3G ISP.
Enter the dial number provided by your 3G ISP.
If no traffic for the present time, the 3G will disconnect automatically.
Within the preset minutes, if the modem does not detect the flow of the
user continuously, the modem automatically stops the 3G connection.
Once it detects the flow (like access to a webpage), the modem
restarts the 3G dialup.
The 3G delays dial after the DSL is disconnected.
You can select DSL OR ETHERNET or 3G from the drop-down list.
The 3G connection
is backup for the
DSL connection.
Figure 5-2-40
58
User Manual of VDR-300NU
DSL: If the DSL is disconnected, the 3G
starts to dial.
IP connectivity: If the system fails to ping
the specified IP address, the 3G starts to dial.