Adding a PPPoA WAN service
This section describes the steps for adding the PPPoA WAN service.
Step1
Choose Advanced Setup > Layer2 Interface > ATM Interface to dsiplay the ATM Interface
Configuration page. On this page, you need to add a PVC for PPPoA mode. Click the Add button
on the ATM Interface Configuration page to display the following page.
Step2
Select the DSL link type to be PPPoA and select the encapsulation mode to be VC/MUX (according
to the uplink equipment). After finishing setting, click the Apply/Save button to apply the settings.
Step3
Choose WAN Service and click Add to display the following page.
Figure 5-2-23
48
User Manual of VDR-300NU