Planet VDR-300NU User Manual page 43

PPP IP extension
Use Static IPv4
Address
Enable IPv6 for this
service
Enable PPP Debug
Mode
Bridge PPPoE
Frames Between
WAN and Local
Ports
Enable IGMP
Multicast Proxy
Step5 After setting the parameters, click Next to display the following page. On this page, select a
preferred WAN interface as the system default gateway.
connection. Once it detects the flow (like access to a webpage), the
modem restarts the PPPoE dialup. If this function is disabled, the
modem performs PPPoE dial-up all the time. The PPPoE
connection does not stop, unless the modem is powered off and
DSLAM or uplink equipment is abnormal.
If you want to configure DMZ Host, you should enable it first.
If this function is disabled, the modem obtains an IP address
assigned by uplink equipment such as BAS, through PPPoE dial-up.
If this function is enabled, the modem uses this IP address as the
WAN IP address.
Enable this function, you can use IPv6 service. It will also need you
to check Request IPv6 Address and Request Prefix Delegation.
Enable or disable this function.
Enable or disable this function.
If you want PPPoE mode to support IPTV, enable it.
Figure 5-2-14
43
User Manual of VDR-300NU