Adding a Bridging WAN service
This section describes the steps for adding the Bridging WAN service.
Step1
First, add a proper ATM or PTM interface for this WAN service at Layer2 Interface.
Step2
On the WAN Service page, click the Add button to display as Figure 5-2-11. You can select
ATM or PTM Interface for the WAN service and then click Next.
Step3
On this page, select the WAN service type to be Bridging. Click Next to finish the setting.
Step4
On this page, it displays the information about the bridge settings. Click Apply/Save to save and
apply the settings. You can modify the settings by clicking the Back button if necessary.
Figure 5-2-21
Figure 5-2-22
47
User Manual of VDR-300NU