Head Alignment (Vertical Slant) - MUTOH ValueJet 1604 Service Manual

VJ-1604 Maintenance Manual
7.8.2

Head Alignment (Vertical Slant)

This section describes the procedure to adjust the head slant in vertical direction.
After operation such as head assembly replacement, adjust the head slant according to the steps below.
• Before starting adjustment, remove the following parts.
CR board cover:
• Before aligning print head in vertical direction, perform the alignment in horizontal direction.
"7.8.1 Head Alignment (Horizontal Height)" p.7-35
In this procedure, align the print head in the direction shown below.
1. Start the plotter in the self-diagnosis function mode and select "Head Slant: Slant 2".
"5.7.3 Head Slant Check Menu" p.5-28
"4.8.3 Replacing CR Board Assembly" p.4-107
Lateral view
Print head
7-37
7 Adjustment
Rev.-05