Steel Belt Tension Adjustment - MUTOH ValueJet 1604 Service Manual

7 Adjustment

7.4 Steel Belt Tension Adjustment

This section describes the procedure to adjust the tension of the steel belt.
When you have removed and installed the steel belt, always adjust the steel belt tension.
7.4.1 Jigs and Tools
The jigs and tools required for steel belt tension adjustment are as follows.
• Tension gauge: for measuring Max. 2N (204gf)
• Adhesive material
Refer to"8.4 Jigs and Tools" p.8-5
7.4.2 Adjustment Procedure
To adjust the steel belt tension, follow the steps below.
1. Open the front cover.
2. Remove the side maintenance cover L.
"4.2.5 Removing Side Maintenance Cover L" p.4-12
3. Press the tension gauge at the center position of the steel belt.
No.
1
2
3
Rev.-05
for the details of jigs and tools required for this work.
1
2
Steel belt
Tension gauge
Y tension attachment
Part name
7-26
VJ-1604 Maintenance Manual
3