4 Parts Replacement
6. Remove the PF_ENC scale.
7. Remove the PF speed reduction belt.
8. Remove the PF speed reduction pulley.
9. Replace the PF speed reduction pulley.
10. Replace the PF_ENC scale.
11. Adjust the PF_ENC scale.
"7.6 PF Encoder Assembly Position Adjustment" p.7-30
12. To reassemble the unit, reverse the removal procedure.
4.6.5
Replacing P_REAR Sensor Assembly
The P_REAR sensor assembly is located near the center of the X rail (joint part of the grid roller).
1. Remove the media guide R (lower).
"4.2.19 Removing Media Guide R (Lower)" p.4-29
2. Open the board box 64.
"4.4.1 Opening Board Box 64" p.4-40
3. Detach the connector (MAIN J42) to the P_REAR_R sensor assembly.
The P_REAR sensor assembly cable is a stranded wire of red, black, blue, and orange.
Rev.-05
4-68
VJ-1604 Maintenance Manual