Sub Controller Installation - MUTOH ValueJet 1604 Service Manual

VJ-1604 Maintenance Manual
4. When sending completes and the "Send
completed" window opens, click [OK].
Almost as soon as the "Send completed" window is displayed, writing to plotter also finishes. If
writing to plotter finishes successfully, the LCD displays the following:
Transfer complete
Buzzer sounds three times and only Power LED turns on. Then, when the LCD displays
16372 bytes recv
parameter writing completes.
7.3.7

Sub Controller Installation

This section describes installation procedures of HEATER_CONT board firmware.
The extension of the sub controller file is ".mfl".
Be very careful of the firmware to transfer. If an improper firmware is installed, the printer
may become unable to operate. In this case, it will be necessary to replace the circuitboard.
1. Click [Sub Controller Install] in the main
window.
7-23
7 Adjustment
Rev.-05