Replacing Cr_Hp Sensor, Lever Sensor - MUTOH ValueJet 1604 Service Manual

VJ-1604 Maintenance Manual
2. Detach the DC cable assembly from the connector to the power board assembly (of take-up section for
foreign use).
2
3. Cut the KI tie that retains the DC cable assembly to replace the DC cable assembly.
4. To reassemble the unit, reverse the removal procedure. Retain the DC cable assembly using the KI tie.

4.13.6 Replacing CR_HP Sensor, Lever Sensor

(1) Replacing W_ON Sensor Relay Assembly, W_OFF Sensor Relay Assembly
Remove the screws that retain the board chassis before replacing W_ON sensor relay assembly or
W_OFF sensor relay assembly.
"(1) Removing Board Chassis" p.4-157
1. Remove the cable of the W_ON sensor relay assembly and W_OFF sensor relay assembly from the
connector to the VJ take-up CNT board assembly.
2
1
1
4-165
4 Parts Replacement
No. Part name
1 Power board assembly (of take-
up section for foreign use)
2 DC cable assembly
No. Part name
1 VJ take-up CNT board assembly
2 Cable of W_ON sensor relay
assembly and W_OFF sensor
relay assembly
Rev.-05