Print Head Endurance (Nozzle Print) Menu - MUTOH ValueJet 1604 Service Manual

VJ-1604 Maintenance Manual
The pump endurance running sequence is as follows.
1. Pump endurance running starts.
2. Pump phase detection is performed.
3. Rotates with the specified suction speed. This rotation is counted as one cycle.
Step 2 above is repeated the number of times specified as follows.
Super high: 4000
High: 3000
Normal: 2000
Low: 1000
4. Pump release is performed.
5. Pump endurance running ends.

5.13.4 Print Head Endurance (Nozzle Print) Menu

This menu performs endurance running for the plot head.
In the sequential plotting endurance menu you can operate sequential plotting endurance operation on the plot
head according to your desired settings.
Table 5-25 Set Item in Sequential Plotting Endurance Menu
Set item
Number of endurance
running cycles
• If the number of endurance running cycles is set to -1, the carriage continuously repeats endurance
running until cancel input is given from the operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit number). If
the number of cycles exceeds the maximum value, the counter is reset to 0.
Contents
Set the number of
endurance running
cycles.
[Enter]
[Enter]
[Enter]
[Enter] or [Cancel]
5-69
Set value
-1 to 10000
Endurance Count
Performing endurance running
5 Self-Diagnosis Mode
Remark
-
Rev.-05