Table of Contents
Advertisement
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
Line
Destination – Day / Night
1001: [SP], [NL], [JT], 2001: [G]
3-4 digits consisting of 0-9
Specifies the destination for the trunk line whose "Incoming Type"
is set to "DIL."
The following numbers can be assigned as the destination:
Extension numbers, FDNs.
(Assignable only when " DIL" is specified in "Incoming Type"
programming.)
• 1.5 Attended Features (F/G)
– Direct In Lines (DIL)
Subscriber
Blank
Up to 16 digits consisting of 0-9
Specifies the number which is used as the CLIP / COLP or ANI
(Automatic Number Indication) number.
None
[CPC Signal] OUT Detection
Disable (ELCOT card), Enable (E1 [DR2] card)
1.
Enable
2.
Disable
Specifies whether CPC Detection on outgoing CO calls is enabled
or disabled.
If enabled, the system disconnects the line with the time set in
programme "[CPC Signal] OUT Detection - Detection Time" when
the CPC signal is detected.
Note
• In some countries, the E1 and the ELCOT cards must not be
connected to the Public Switched Network.
• 1.3 System Features (F/G)
– Calling Party Control (CPC) Signal Detection
4.2 Trunk Line
139
Advertisement
Table of Contents
