Dayl. Dri. Lights (Day Light) - Skoda Superb Owner's Manual

The light switch or the control dials
A
lowing functions » Fig. 31.
Switching on the parking light or parking lights on both sides.

Switching on the low beam.

Switching off lights (except daytime running lights).

Headlight beam adjustment.

Adjust brightness of the instrument lighting.

Lights and visibility
Turning the rotary switch from position
B
light beam adjustment, thereby shortening the beam of light
The positions of the width of illumination correspond approximately to the fol-
lowing car load.
Front seats occupied, boot empty.
-
All seats occupied, boot empty.
1
All seats occupied, boot loaded.
2
Driver seat occupied, boot loaded.
3
Instrument lighting
The instruments are also illuminated when the side light, low or high beam light
is switched on.
Turning the rotary switch when the lights are switched on adjusts the bright-
C
ness of the instrument lighting » Fig. 31
WARNING
Always adjust the headlight beam to satisfy the following conditions.
The vehicle does not dazzle other road users, especially oncoming vehicles.
■
The beam range is sufficient for safe driving.
■
Note
We recommend you adjust the headlight beam when the low beam is switched
■
on.
The Bi-Xenon bulbs adapt automatically to the load and driving state of the ve-
■
hicle when the ignition is switched on and when driving. Vehicles that are equip-
ped with Bi-Xenon headlights do not have a manual headlight range adjustment
control.
and/or is used to operate the fol-
B C
to gradually activates the head-
- 3
» Fig. 31.
.

Dayl. dri. lights (DAY LIGHT)


First read and observe the introductory information and safety warn-
ings on page 48.
The daytime running lights function provides the lighting of the front of the vehi-
cle.
Deactivating the function daylight driving lights
›
Pull the turn signal and main beam lever to the steering wheel and push down-
wards » Fig. 32 on page 50.
›
At the same time switch on the ignition and hold the lever down in this position
for at least 3 seconds.
Activating the function daylight driving lights
›
Pull the turn signal and main beam lever to the steering wheel and push up-
wards » Fig. 32 on page 50.
›
At the same time switch on the ignition and hold the lever down in this position
for at least 3 seconds.
The daylight driving lights can also be activated or deactivated via the information
display in the menu item Dayl. dri.
The daytime running lights are switched on automatically if the following condi-
tions are met:
The ignition is switched on.

The light switch is in the position 0 or 

Note
When the daytime running light is switched on, the side lights (neither at the
front or rear) and the number plate lights are not lit.

light» page 27.
» Fig. 31 on page 48.
Lights and visibility

49