Skoda Superb Owner's Manual page 27

Reseting
›
Select one of the elements of the multi-function display
mation.
›
Select the desired memory.
›
Press and hold the button » Fig. 10
B
The following values of the selected memory are set to zero.
›
Average fuel consumption.
›
Distance driven.
›
Average speed.
›
Driving time
Single-trip memory (memory 1)
The single-trip memory collates the driving information from the moment the ig-
nition is switched on until it is switched off. New data will also flow into the cal-
culation of the current driving information if the trip is continued within 2 hours
after switching off the ignition. If the trip is interrupted for more than 2 hours,
the memory is automatically erased.
Total-trip memory (memory 2)
The total trip memory collates the data from any number of individual trips up to
a total of 19 hours and 59 minutes, or 1999 km distance or, for vehicles with infor-
mation display, 99 hours and 59 minutes, or 9999 km distance. The memory is de-
leted when either of these limits is reached and the calculation starts all over
again.
Unlike the single-trip memory, the total-trip memory is not deleted after a period
of interruption of driving of 2 hours.
Note
All information in the memory 1 and 2 is erased if the battery of the vehicle is dis-
connected.
1)
If no value is set the output value 30 km/h is automatically displayed.
» page 23, Select Infor-
on page 23 or adjustment wheel
D
Warning against excessive speeds

First read and observe the introductory information and safety warn-
ings on page 22.
.
Adjust the speed limit while the vehicle is stationary
›
Press button » Fig. 10
A
the menu option Speed warning (Information display) or  (Segment display).
›
Press button or the adjustment wheel
B
tings options .
1)
›
Press button or turn adjustment wheel
A
50 km/h.
›
Confirm the speed limit by pressing button
around 5 seconds. Your settings will then be saved automatically.
The speed limit can be adjusted from 30 km/h to 250 km/h in 5 km/h increments.
Adjusting the speed limit while the vehicle is moving
›
Press button » Fig. 10
A
the menu option Speed warning (Information display) or  (Segment display).
›
Drive at the desired speed, e.g. 50 km/h.
›
Press the button or the adjustment wheel
B
the speed limit.
If you wish to change the set speed limit, it is changed in 5 km/h intervals (e.g. the
accepted speed of 47 km/h increases to 50 km/h or decreases to 45 km/h).
›
Confirm the speed limit by pressing button
around 5 seconds. Your settings will then be saved automatically.
Change or disable speed limit
›
Press button » Fig. 10
A
the menu option Speed warning (Information display) or  (Segment display).

›
Press button or adjustment wheel
B
›
Press button or adjustment wheel
B
speed limit.
If the set speed limit is exceeded, an audible signal will sound as a warning. At
the same time the display shows the menu Speed warning (Information display)
or  (Segment display) with the set threshold.
The set speed limit value remains stored even after switching off the ignition.
on page 23 or turn the adjustment wheel
to activate the the speed limit set-
D
to set the desired speed limit, e.g.
D
, or adjustment wheel
B
on page 23 or turn the adjustment wheel
to accept the current speed as
D
B or adjustment wheel
on page 23 or turn the adjustment wheel
to delete the speed limit.
D
again to activate change mode for the
D
Information system
to select
D
or wait
D
to select
D
D or wait
to select
D

25