Operating The Lights; Daylight Driving Lights (Day Light) - Skoda yeti Owner's Manual

Operating the lights


Read and observe on page 59 first.
To switch on/off the lights, turn the
positions (equipment-dependent).
Switching off lights (except daytime running lights)

Automatic switching lights on and off

Switching on the parking lights or parking lights on both sides

Switching on the low beam

To adjust the headlight range control, turn dial
hicle load » .
Front seats occupied, luggage compartment empty

All seats occupied, luggage compartment empty

All seats occupied, luggage compartment loaded

Driver seat occupied, luggage compartment loaded

The Xenon headlights feature no manual headlight range control. After
switching on the ignition, adjust these automatically to the load and driving
condition of the vehicle.
WARNING
Always adjust the headlight beam to meet the following conditions - other-
wise there is a risk of an accident.
The vehicle should not dazzle other road users, especially oncoming vehi-
■
cles.
The beam range is sufficient for safe driving.
■
1) Does not apply to the position , as long as the conditions are met for the COMING HOME function
» page 62.
60
Using the system
Fig. 42
Light switch and control dial for
the headlight beam range regu-
lation
» fig. 42 switch to one of the following
A
» page 61
» page 63
» fig. 42in line with the ve-
B
Notice
If, with a dipped beam, the ignition is turned off, then the dipped beam will
■
automatically switch off and the parking lights will come on. The parking
1)
lights are switched off when the ignition key is removed (for vehicles with the
KESSY system, after opening the driver's door).
If there is a fault in the light switch, the low beam illuminates automatically.
■

Daylight driving lights (DAY LIGHT)


Read and observe on page 59 first.
The daytime driving lights (hereinafter referred to only function)ensure the
lighting of the front and also the rear vehicle area (only valid for some coun-
tries).
The lights are switched on automatically if the following conditions are met:
The light switch is in the position  or .

The ignition is switched on.

The function is activated.

Function for vehicles with MAXI DOT display disable / enable
The function menu item Dayt. r. light can be deactivated / activated
Menu item settings.
Disable function for vehicles with segment display
›
Turn off the ignition, pull the indicator / main beam lever towards the steer-
ing wheel, push down and hold in this position.
›
Switch on the ignition and hold the lever in the above position until an audi-
ble signal sounds (about 3 s).
Enable function for vehicles with segment display
›
Turn off the ignition, pull the indicator / main beam lever towards the steer-
ing wheel, push down and hold in this position.
›
Switch on the ignition and hold the lever in the above position until an audi-
ble signal sounds (about 3 s).
WARNING
Therefore always switch on the low beam if visibility is poor.
» page 45,