The driving speed during the parking procedure was too high - automatic brake
assist is initiated.
Cruise control system
Introduction
This chapter contains information on the following subjects:
Activating/deactivating
Storing and maintaining speed
Changing the stored speed
Temporarily deactivating
The Cruise Control System (CCS) maintains a set speed, more than 25 km/h, with-
out you having to actuate the accelerator pedal.
This is only possible within the range which is permitted by the power output and
braking power of the engine.
The warning light
illuminates in the instrument cluster when the cruise control
system is switched on.
WARNING
For safety reasons, the cruise control system must not be used in dense
■
traffic or on unfavourable road surfaces (such as icy roads, slippery roads,
loose gravel) – risk of accident!
The saved speed may only be resumed if it is not too high for the current
■
traffic conditions.
Always deactivate the cruise control system after use to prevent the system
■
being switched on unintentionally.
CAUTION
The cruise control system is not able to maintain a constant speed when driving
■
in areas with steeper gradients. The weight of the vehicle increases the speed at
which it travels. In such cases, select a lower gear or brake the vehicle using the
footbrake.
The cruise control system cannot be activated when first gear or reverse gear is
■
selected (vehicles with manual transmission).
The cruise control system cannot be activated when the selector lever is in po-
■
sitions P , N or R (vehicles with automatic transmission).
The cruise control system may automatically switch off when some brake assist
■
systems (e.g. ESC) intervene, when the maximum permissible engine speed is ex-
ceeded, etc.
Activating/deactivating
155
155
156
156
First read and observe the introductory information and safety warn-
ings
on page 155.
Activating
›
Turn the switch
» Fig. 140
A
Deactivating
›
Turn the switch
» Fig. 140
A
Storing and maintaining speed
First read and observe the introductory information and safety warn-
ings
on page 155.
›
Activate the cruise control system
›
Drive at the desired speed.
›
Push the rocker button
After you have released the rocker button
you have just stored is maintained at a constant speed without having to depress
the accelerator.
Fig. 140
Operating lever: Rocker switch
and switch of the cruise control
system
into the ON position.
into the OFF position.
» page
155.
into the SET
» Fig. 140
on page 155 position.
B
out of the position SET, the speed
B
Assist systems
155