Daylight Running Lights (Day Light); Turn Signal And Main Beam; The Maximum Permissible Overhang Of The Ball Head Of The Towing Hitch Is - Skoda Superb B8 Owner's Manual

All seats occupied, boot loaded

Driver seat occupied, boot loaded

Xenon headlight
The Xenon bulbs adapt automatically to the load and driving state of the vehi-
cle when the ignition is switched on and when driving. Vehicles that are equip-
ped with Xenon headlights do not have a manual headlight range adjustment
control.
WARNING
Always set the headlight range control so that other road users are not
dazzled, in particular oncoming vehicles.
Note
The light switch is in position  or  and the ignition is turned off, the low
■
beam is switched off automatically
switched off when the ignition key is removed, for vehicles with the KESSY
system after switching off the ignition and opening the driver's door.
If there is a fault in the light switch, the low beam comes on automatically.
■

Daylight running lights (DAY LIGHT)


Read and observe on page 69 first.
The daytime running lights (hereafter as function) provides the lighting of the
front vehicle range.
The lights are switched on automatically if the following conditions are met.
The light switch is in the position  or .

The ignition is switched on.

The function is activated.

WARNING
When the daytime running light is switched on, the side lights (neither at
the front or rear) and the number plate lights are not lit. Therefore always
switch on the low beam when the visibility is poor.
1) Does not apply to the position , as long as the conditions are met for the COMING HOME function
» page 73.
70
Using the system
and the status light is lit. The side light is
1)

Turn signal and main beam


Read and observe on page 69 first.
Lever positions » Fig. 53
When the right turn signal light is switched on, the warning light flashes in
A
the instrument cluster

When the left turn signal light is switched on, the warning light flashes in
B
the instrument cluster

Depending on equipment (spring-tensioned position):
C
›
Switch on main beam - the warning light illuminates in the instrument
cluster

›
Enable headlamp assistant
Depending on equipment (spring-tensioned position):
D
›
Switch off main beam / headlight flasher on (spring-tensioned position)
›
Deactivate headlamp assistant / Headlight flasher switch on (spring-
tensioned position)
The main beam can only be switched on when the low beam lights are on.
The headlight flasher can be operated even if the ignition is switched off.
The turn signal light switches itself off automatically when driving around a
curve or after making a turn.
"Convenience turn signal"
When the control lever is lightly pressed to the pressure point
the respective turn-signal lamp flashes three times.
Fig. 53
Operating lever: Turn signal and
main beam operation
» page 74
or
A
then
B
