Operating The Light Function; Daytime Running Lights(Day Light) - Skoda Rapid Spaceback Owner's Manual

Table of Contents

Advertisement

Operating the light function

Read and observe
on page 53 first.
To switch on/off the lights, turn the
positions (equipment-dependent).
Switching off lights (except daytime running lights)
Switching lights on/off automatically

Switching on the parking lights or parking lights on both sides
Switch on low beam
To adjust the headlight range control, turn dial
vehicle load
»
.
Front seats occupied, boot empty
All seats occupied, boot empty
All seats occupied, boot loaded
Driver seat occupied, boot loaded
WARNING
Always adjust the headlight beam to meet the following conditions - other-
wise risk of accident.
The vehicle does not dazzle other road users, especially oncoming vehi-
cles.
The beam range is sufficient for safe driving.
1)
Does not apply to the position , as long as the conditions are met for the COMING HOME function
» page
56.
54
Using the system
Fig. 40
Light switch and control dial for
headlight range adjustment
» Fig. 40
switch to one of the following
A
» page 55
» page 57
» Fig. 40
in line with the
B
Note
If, with a low beam, the ignition is turned off, then the dipped beam will au-
tomatically switch off
and the parking lights illuminate. The parking lights are
1)
switched off when the ignition key is removed (for vehicles with the KESSY
system, after opening the driver's door).
If there is a fault in the light switch, the low beam comes on automatically.

Daytime running lights(DAY LIGHT)

Read and observe
on page 53 first.
The daytime running light (hereinafter referred to as "function") lights the
front and rear vehicle area (only valid for some countries).
The lights are switched on automatically if the following conditions are met.
The light switch is in the position  or .
The ignition is switched on.
The function is activated.
Activating/deactivating function on vehicles with Infotainment
This function can be activated/deactivated in Infotainment
- Infotainment.
Deactivating on vehicles without Infotainment
Pull the indicator / main beam lever towards the steering wheel, push down
and hold in this position.
Switch on the ignition and hold the lever in the above position until you hear
a signal (about 3 s).
Activating on vehicles without Infotainment
Pull the indicator / main beam lever towards the steering wheel, push up and
hold in this position.
Switch on the ignition and hold the lever in the above position until you hear
a signal (about 3 s).
WARNING
Always switch on the low beam when visibility is poor.
»
Owner´s Manual

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rapid

Table of Contents