Operating The Lights; Daylight Running Lights (Day Light) - Skoda SUPERB Owner's Manual

Hide thumbs Also See for SUPERB:
Table of Contents

Advertisement

Operating the lights

Read and observe
on page 63 first.
To switch on/off the lights, turn the
positions (equipment-dependent).
Switching off lights (except daytime running lights)
Switching lights on/off automatically

Switching on the parking lights or parking lights on both sides
Switching on the low beam
Headlight range control of the Halogen headlights
Press the
button on the Infotainment and then press the function keys in

the display one after the other  Tap on → Light → headlight range control (if
applicable Light Assist - depending on Infotainment type).
Depending on the load of the vehicle, the headlight beam of the Halogen
headlights can be set to the following basic settings.
Front seats occupied, boot empty
All seats occupied, boot empty
All seats occupied, boot loaded
Driver seat occupied, boot loaded
Depending on the load of the vehicle, the positions . .  can also be set.
The Xenon headlights feature no manual headlight range control. After
switching on the ignition, adjust these automatically to the load and driving
condition of the vehicle.
1)
Does not apply to the position , as long as the conditions are met for the COMING HOME function
» page
67.
64
Using the system
Fig. 45
Light switch
» Fig. 45
switch to one of the following
A
» page 65
» page 67
WARNING
Always adjust the headlight range control to comply with the following
conditions and prevent accidents.
The vehicle does not dazzle other road users, especially oncoming vehi-
cles.
The beam range is sufficient for safe driving.
Note
If, with a dipped beam, the ignition is turned off, then the dipped beam will
automatically switch off
and the parking lights illuminate. The parking lights
1)
are switched off when the ignition key is removed (for vehicles with the KESSY
system, after opening the driver's door).
If there is a fault in the light switch, the low beam comes on automatically.

Daylight running lights (DAY LIGHT)

Read and observe
on page 63 first.
The daytime running lights illuminate the area in front of and to the rear of the
vehicle (only applicable for some countries).
The lights are switched on automatically if the following conditions are met.
The light switch is in the position  or .
The ignition is switched on.
WARNING
Always switch on the low beam when visibility is poor.
Note
The light can operate automatically under certain circumstances, even if the
light switch is in position .

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents