Skoda Superb Owner's Manual page 115

All communication between a telephone and the hands-free system of your vehi-
cle can only be established with the help of the following profiles of Bluetooth
technology.
rSAP - Remote SIM access profile
After connecting the telephone with the hands-free system via the rSAP profile,
the telephone deregisters from the GSM network, and communication with the
network is only enabled by the hands-free system via the vehicle's external aerial.
In the telephone only the interface for Bluetooth
you can only use the mobile phone to disconnect from the hands-free system, de-
®
activate the Bluetooth connection or dial the emergency number 112 (only valid
in some countries).
HFP - Hands Free Profile
After connecting the telephone with the hands-free system via the HFP profile,
the telephone continues to use its GMS module and the internal antenna to com-
municate with the GSM network.
Note
The following guidelines must be observed
way radio systems.
Connecting the phone to the hands-free system

First read and observe the introductory information given on page 112.
To connect a mobile phone with the hands-free system, it is necessary to inter-
connect the telephone and hands-free system. Detailed information on this is
provided in the operating instructions for your mobile phone. The following steps
must be carried out for the connection.
Connecting the telephone with the hands-free system via the rSAP profile
›
®
Activate Bluetooth and the visibility of your mobile phone on your telephone.
For certain mobile phones it is necessary to switch on first the rSAP function.
›
Switch on the ignition.
®
1)
Depending on the Bluetooth version on the mobile phone, an automatically generated 6-digit PIN
(SSP) will either be displayed, or a 16-digit code displayed in the information display will need to be
entered into your mobile phone and confirmed within 30 seconds by following the instructions on
your mobile phone display.
®
remains active. In this case,
» page 106, Mobile phones and two-
›
Select the Phone - New user menu in the information display and wait until the
®
hands-free system has completed the search.
›
Select the phone you wish to connect from the list of units found.
›
Confirm the PIN .
1)
›
If your SIM card is blocked by a PIN code, enter the PIN code for the SIM card in
your phone. The telephone connects to the hands-free system (during the first
connection you can only enter the PIN code in the information display when the
vehicle is stationary, as this is the only situation when you can choose whether
the PIN code should be stored).
›
Follow the instructions in the information display, the first time a new user is
stored.
›
Reconfirm the rSAP command on your mobile phone to download the tele-
phone book and the identification data from the SIM card into the hands-free
system.
Connecting the telephone with the hands-free system via the HPP profile
›
®
Activate Bluetooth and the visibility of your mobile phone on your telephone.
›
Switch on the ignition.
›
Select the Phone - New user menu in the information display and wait until the
hands-free system has completed the search.
›
Select the phone you wish to connect from the list of units found.

›
Confirm the PIN .
1)
›
Follow the instructions on the information display and the mobile phone to
store a new user or to download the telephone book and identification data
from the SIM card into the hands-free system.
The telephone primarily connects via the rSAP profile.
If the PIN code was stored, the telephone is automatically detected and connec-
ted with the hands-free system the next time the ignition is switched on. Check
your mobile phone to see whether this automatic connection has been establish-
ed.
Communication and multimedia

113