Skoda Superb Owner's Manual page 163

Adjusting the ready position
Fig. 143 Setting the ready position/ready position

First read and observe the introductory information and safety warn-
ings on page 160.
Always adjust the ball head in the ready position before fitting.
›
Turn the key so that its red marking is visible
1
›
Grip the tow bar below the protective cap
›
Press the release pin 3 in the direction of the arrow to the stop, and simulta-
neously push the lever downwards in the direction of the arrow to the stop.
4
The lever remains locked in this position.
CAUTION
In the ready position, the key cannot be removed nor turned to a different posi-
tion.
» Fig. 143.
.
2
Fitting the tow bar
Fig. 144 Insert the ball head/lock the lock, and put the lock cover on

First read and observe the introductory information and safety warn-
ings on page 160.
›
Pull cap » Fig. 142 on page 160 downwards.
4
›
Put the tow bar in the ready position
›
Grip the tow bar from underneath
cess until you hear it click into place
The lever automatically turns upwards and the release pin
1
and green parts are visible) »
If the lever does not turn automatically, or if the release pin
1
out, remove the tow bar from the mounting recess by turning the lever down-
wards as far as it can go. Clean the tapered surfaces on the tow bar and the
mounting recess.

›
Lock the lock on the operating lever by turning the key
(see green marking 3 is visible) and remove the key in the direction of the arrow.
›
Insert the cap onto the lock in the direction of the arrow
4
›
Check that the tow bar is securely attached
WARNING
Keep your hands outside the lever's range of motion when attaching the
■
tow bar – risk of finger injuries!
Never attempt to pull the operating lever upwards forcibly to turn the key.
■
Doing so would mean the ball head is not attached correctly.
» page 161.
» Fig. 144 and insert into the mounting re-
» .
pops out (its red
2
.
does not pop
2
by 180° to the right
3
» .
» page 162.
Towing a trailer

161