Daylight Running Lights (Day Light); Turn Signal And Main Beam - Skoda Citigo Owner's Manual

To switch the light function on / off, switch
one of the following positions.
Switching off lights (except daytime running lights)

Switching lights on/off automatically

Switch on daytime running lights and side lights or parking lights

» page 52
Turn on the low beam

To adjust the headlight range control, turn dial
vehicle load » .
Front seats occupied, boot empty

All seats occupied, boot empty

All seats occupied, boot loaded

Driver seat occupied, boot loaded

WARNING
Always adjust the headlight beam to meet the following conditions - other-
wise risk of accident.
The vehicle does not dazzle other road users, especially oncoming vehi-
■
cles.
The beam range is sufficient for safe driving.
■
Note
If the light switch is in the position , the ignition key is removed and the
driver's door is open, an audible warning signal will sound. After a few seconds
or after closing the driver's door, the audible alarm switches off, but the park-
ing lights will remain switched on.

Daylight running lights (DAY LIGHT)

The daytime running lights light up the area in front of and to the rear of the
vehicle (only applicable for some countries).
The daytime running lights are switched on automatically if the following
conditions are met.
The ignition is switched on.

The lights switch is in position, or.

The light switch is in position  and the fog lights are turned on, the daytime
running lights will turn off.
50
Using the system
» Fig. 38 should be turned to
A
» page 51
» Fig. 38 in line with the
B
WARNING
Always switch on the low beam when visibility is poor.

Turn signal and main beam

Control stalk positions » Fig. 39
Switch on right turn signal

Switch on left turn signal

Switch on main beam (spring-tensioned position)

Switching off main beam / switching on headlamp flasher (spring-loaded

position)
The main beam can only be switched on when the low beam lights are on.
The headlight flasher can be operated even if the ignition is switched off.
The turn signal switches off automatically, depending on the steering angle
after completing the turn.
Comfort signalling
When the operating lever is pressed lightly up or down, the indicator in ques-
tion flashes three times.
WARNING
Only turn on the main beam or the headlight flasher if other road users will
not be dazzled.
Note
An acoustic warning signal will sound when the driver's door is opened if the
lever is not in the middle position after removing the ignition key from the igni-
tion lock. The acoustic warning signal will stop just as soon as the driver's door
is closed.
Fig. 39
Operating lever: Turn signal and
main beam operation