Table 7.6 Link Control Parameters - Samsung OfficeServ 7200 Technical Manual

OfficeServ 7200
TECHNICAL MANUAL
Refer to the following table for a description of each Link Control parameter.
Field
Name
Link Type
IP Address
Telephone
Data Port
File Port
COM Port
Baud rate
[Delete] Button
[Update] Button
[Apply] Button
[Close] Button

Table 7.6 Link Control Parameters

Used to enter the name of the customer site.
Used to select the connection
type for the PC doing OIT
administration.
If the Link type is set to LAN, this parameter can be modified.
Enter the IP Address assigned to the
MP10/MP10a/MCP/MP20/MP40.
If the Link type is set to Modem, this parameter can be
modified.
Enter the phone number associated to the OfficeServ 7000
Series system modem (Not supported on the OS 7200).
If the Link type is set to LAN, this parameter can be modified.
Enter the port number that the OfficeServ Installation Tool will
use to connect to the MP10/MP10a/MCP/MP20/MP40 over
the LAN connection (only use in specific circumstances such
as NAT).
If the Link type is set to LAN, this parameter can be modified.
Enter the port number that the OfficeServ Installation Tool
will use for file transfers to the MP10/MP10a/MCP/MP20/MP40
over the LAN connection (only use in specific circumstances
such as NAT).
If the Link type is set to Modem, this parameter can be
modified.
Select the modem's COM port.
If the Link type is set to Modem, this parameter can be
modified.
Select the appropriate modem speed.
Used to delete the selected site information.
Used to store the selected site information.
Used to select the site which the OIT will connect to when the
[Connect] button is clicked.
Used to close the Link Control window.
7.42
Details
1. LAN – Local Area
Network
2. MODEM (Not
supported on the OS
7200.)
INSTALLATION
PART 7 MAY 2010