Samsung OfficeServ 7200 Technical Manual page 123

OfficeServ 7200
TECHNICAL MANUAL
Figure 7.26 Attaching the iDCS 64 Button Module to an iDCS Keyset
ATTACHING iDCS 14 BUTTON MODULES TO AN iDCS KEYSET
To add an iDCS 14 Button Key Strip to your iDCS keyset, follow these steps
1) Place the keyset face down on a flat surface.
2) Remove the base pedestal by placing your thumbs over the attachment clips and press
outward while simultaneously pressing down on the keyset body with your fingertips.
3) Remove the ribbon cable knockout from the bottom of the keyset.
4) Clip the 14 button strip to the side of the keyset.
5) Plug one end of the ribbon cable into the keyset and the other end into the 14 button
strip.
6) Place the support bracket over the ribbon cable and secure with the six screws provided.
7) Reattach the base pedestal.
Home Page
7.25
Table of Contents
INSTALLATION
PART 7 MAY 2010
(see Figure 7.26).