Samsung OfficeServ 7200 Technical Manual page 98

OfficeServ 7200
TECHNICAL MANUAL
ORDERING A T1
The following information may be useful when ordering T1 service from the telephone
company.
PARAMETERS supported on OfficeServ all TEPRI cards
FRAMING
Super Frame (D4 56K Frame)
Extended Super Frame (ESF 64K Frame)
CODING
AMI - 56K Coding
B8ZS - ESF 64k Coding
NFAS (Non Facility Associated Signaling)
Use MMC 808 to set the parameters to match the Telco T1 span.
T1/E1/PRI Port
Pin No. 1
T1/PRI Rx+
Function
E1
Function
6.2.3 Connecting a SIP Trunk
There is no physical SIP trunk card required to use the SIP trunking service. However, in order
to use the SIP trunking service, the OfficeServ system must be IP-enabled. That means that
the OfficeServ system must have an MGI card with the latest MP software and have high
speed Internet connection.
Please refer to the "OfficeServ Series SIP Trunking Quick Reference Document" for
configuration.
T1 Circuit
T1 Circuit
Not Supported
T1/PRI Port
(RJ-45)
2 3 4
Rx- - Tx+
NOT SUPPORTED IN USA
Figure 6.2 RJ-45 Port of TEPRI/TEPRIa Board
6.3
Home Page
PART 6 MAY 2010
PRI Circuit
Yes Not Supported
Yes Yes
PRI Circuit
Yes Not Supported
Yes Yes
Not Supported
5 6 7
Tx- - -
Table of Contents
INSTALLATION
8
-