OfficeServ 7200
TECHNICAL MANUAL
3.2.6 LCP LEDs
The front view of the LCP board is shown in the picture below.
The LCP front panel components have the functions below:
Ports & LEDs
LINK1~LINK3
SIO
RST
RUN LED
MCP/MP20 LED
3.2.7 Optional Daughterboards
There are 4 types of optional daughter boards that can be installed ONLY on the MCP/MP20.
Each optional daughterboard must be installed in specific positions of the MCP/MP20
Figure
3.10). Each optional daughterboard is described below:
• Multi-Frequency Module (MFM): The MFM is installed in the 3
MCP/MP20. This board provides an additional 12 DSP circuits for DTMF tone detection.
This board has been discontinued as of 05/2009. The CRM daughter board is a replacement for
this part.
Figure 3.9 Front View of the LCP
Table 3.5 Ports and LEDs of the LCP
Ports that connect the MCP/MP20 with the LCP.
Serial port (for Samsung Engineering Use ONLY)
Button for resetting the LCP board.
This LED indicates the status of the LCP.
- Off: Power is not connected.
- On: Booting.
- Blinking: Program in operation.
This LED indicates the status of signaling message processing.
- Off: There's no message exchange between MCP/MP20 and LCP.
- On: Messages are being exchanged between MCP/MP20 and LCP.
3.11
Home Page
Function
rd
Table of Contents
INSTALLATION
PART 3 MAY 2010
(see
position of the