Samsung OfficeServ 7200 Technical Manual page 146

OfficeServ 7200
TECHNICAL MANUAL
3) Make sure the memory backup switch on MCP is in the OFF position for 60 seconds
before putting it in the ON position.
4) Turn on the power of the OfficeServ 7200 expansion cabinet first, then turn on the
power of the main cabinet.
5) Check the LEDs of the MCP and LCP boards.
6) The RUN LED of the MCP card lights green and the SM LED flashes when the system
normally starts the booting process.
7) Once the booting is complete, the RUN LED of the MCP board flashes green, and the SM
LED stops flashing and remains steady GREEN. At this time the system created a default
database with the current hardware configuration and DIP switch settings of S3 on the
MCP.
8) The RUN LED of the LCP board flashes green when the power supply and processor
status of the expansion rack is normal.
If the Media Card is not detected
If the system cannot detect the media card, the MC/SM LED of the MCP board might
not light or flash. In such cases, turn off the power of the main cabinet, replace the
media card and turn the power on again. If the media card is still not detected, turn
off the power of the main cabinet and eject the MCP board.
9) Check if the LED status of other interface boards are normal.
10) If the LED status of the MCP, LCP, or interface board is abnormal, turn off the power of
the cabinet and turn the power on again. If this does not restore normal system
operation contact Samsung Technical Support.
8.2.2 Starting the System with MP20
The procedure for starting the OfficeServ 7200 system is as follows:
1) Check if the boards and cables are properly mounted and connected to the OfficeServ
7200 cabinet.
2) Make sure the Secure Digital (SD) media card with the system software is in the Media
Card slot.
3) Turn on the power of the OfficeServ 7200 expansion cabinet first, then turn on the
power of the main cabinet.
4) After three minutes of RUN LED and SM LED activity, press the RESET SWITCH on the
faceplate of the MP20 processor card and hold it for 10 seconds. This will create a default
database with the current hardware configuration and DIP switch settings of S3 on the
MP20.
5) The RUN LED will change from GREEN to AMBER and will stop flashing after 10 seconds.
Release the RESET button and wait 3 minutes for the system to boot into service.
6) The RUN LED of the MP20 board lights green and the SM LED flashes when the system
normally starts the booting process.
Home Page
8.2
Table of Contents
INSTALLATION
PART 8 MAY 2010