Samsung OfficeServ 7200 Technical Manual page 114

Table of Contents
Home Page
OfficeServ 7200 INSTALLATION
TECHNICAL MANUAL PART 7 MAY 2010
1
2 3
USED FOR ATTACHING
AOM OR 64B MODULE
WITH CONNECTOR CLIP
HOLES FOR MOUNTING SCREWS
NOTE: THE DIRECTORY CARD SLIDE TRAY IS NOT
Figure 7.20 Ultra Base Wedge
WALL-MOUNTING KEYSETS WITH ULTRA BASE WEDGE
The keysets now come equipped with a new Ultra Base wedge. These base wedges are
reversible and can be used for wall-mounting however not every wall mounting scenario is
appropriate. First and foremost there is only one keyhole in the center of the base attaching
to the wall, and these base wedges can not be used with the standard wall mount bracket
with the two buttons/pins. To wall-mount the keyset using Ultra Base wedges use screw holes
1, 2 and 3 to mount the base wedge on dry wall with the hole in the middle for cable access
(see Figure 7.20).
WALL-MOUNTING iDCS KEYSETS
iDCS keysets come equipped with a reversible base wedge. To wall-mount a keyset, remove
the wedge from the keyset and mount the wedge to the wall using one of the methods below
(see Figure 7.21).
Use screw holes 1 and 2 to attach the base wedge to a standard electrical outlet box.
7.16