Ethernet Parameters - Samsung OfficeServ 7100 Technical Manual

OfficeServ 7100
TECHNICAL MANUAL
MMC: 830
DESCRIPTION:
This MMC provides the means to configure the Internet Protocol (IP) addressing of
the OfficeServ 7100 system MP10 card. This MMC must be utilized if there are ITP
series phones and/or MGI cards used on the system. Even without any VoIP
applications you still have to configure the MP10 IP for LAN based OfficeServ 7100
box connections.
NOTE: When changing any IP address/value, listed below, three digits must
be input for each (octet) field. Example 192.168.1.10 input must be: 192 168
001 010
PLEASE ALSO NOTE: The first 3 parameters: SYSTEM IP ADDR, SYSTEM
GATEWAY, and SYSTEM NET MASK are stored separate from the main
system database, thus will not be defaulted when MMC811 "CLEAR
MEMORY" is performed. Furthermore, any changes to these parameters will
not be applied until the MP is reset.
• SYSTEM IP ADDR: Specifies the IP address for the MP10 card.
• SYSTEM GATEWAY: Specifies the designated LAN gateway IP address used
for contacting IP devices beyond the local network subnet.
• SYSTEM NET MASK: Specifies the IP subnet mask. This parameter is used by
the system to calculate the range of IP devices (subnet) that are within "direct
reach" of the MP10 (without having to go through the designated network IP
gateway).
• SYSTEM RESET: Prompt to restart system MP10 when system IP address is
changed. This reset is similar to MMC 811. You must use this reset for any
changes in this MMC to take effect.
• SYSTEM IP TYPE: Defines which IP addressing relationship is used for
communications to and from the MP10 card.
PRIVATE IP ONLY – the system assumes all ITP/VOIP devices are on the
same network. Traffic involving non-IP based devices (such as analog trunks,
digital keysets, voicemail, etc.) are handled VIA the MGI card.
PRIVATE w PUBLIC – the system knows that there is a mixture of ITP/VOIP
devices on the same network and on remote network(s), thus communicates
accordingly based upon the entries in MMC 840 (for ITP phones) or MMC
838 (for other MP10).

ETHERNET PARAMETERS

PROGRAMMING
PART 2 APRIL 2007