Stirring The Toner - Canon iR2200 Service Manual

CHAPTER 3 INSTALLATION

2.7 Stirring the Toner

Work
1) Connect the power plug to the power
outlet.
2) Turn on the main power switch.
• Wait until the control panel indicates
that the machine is ready for operation.
3) Start service mode.
4) Make the following selections:
COPIER>FUNCTION>INSTALL>TONER-
S.
5) Press the OK key.
• The stirring operation will last for 240
sec (4 min), after which the operation
stops automatically.
6) Press the Reset key twice to end service
mode.
7) Execute 'roller clean' in user mode ('ad-
just/clean'), and execute transfer charg-
ing roller resistance detection control
(ATVC).
3-12 S
COPYRIGHT © 2001 CANON INC.
Checks/remarks
Press the
same time, and the
Display I/O
<INSTALL >
TONER-S
STRD-POS
CARD
2000 2000 2000 2000 CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001
The power supply
must be as rated. (The
voltage may be ±
10% of the rating, but
it must have the rated
amperage.)
key, '2' and '8' at the
key once again.
The following mes-
sage will appear:
"CHECK THE DE-
VELOPER." In re-
sponse, check to see if
the developing assem-
bly is properly locked
in place.
If you inadvertently
stopped stirring of the
toner in the middle, be
sure to execute
'TONER-S' once
again.
Adjust Function Option
< 1/ 1 > <NO-PAPER>
Check the Developer
0 →(
0) { 1 - 2700}
+/-
Test Counter
OK