Removing The Deck Main Motor (M1D); Removing The Deck Lifter Motor (M2D) - Canon iR2200 Service Manual

3.3.3 Removing the Deck Main Motor (M1D)

1) Remove the rear cover. (p. 8-20P)
2) Disconnect the connector [1], and re-
move the two screws [2] : then, detach
the deck main motor [3].
At this time, take care not to
damage the gear at the tip of the
motor spindle.

3.3.4 Removing the Deck Lifter Motor (M2D)

1) Sliding out the compartment. (p. 8-17P)
2) If the lifter is up, move it so that it is
about 7 cm from the base plate of the
compartment. (p. 8-20P)
3) Fit a hex wrench [2] into the opening in
the lifter drive shaft [1] to fix the lifter
drive shaft [3] in place (against rota-
tion).
COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001
CHAPTER 8 PAPER DECK-L1
[2]
[1]
F08-303-02
[3]
[2]
F08-303-03
[3]
[2]
[4]
A
8-31 P