Stirring Toner; Setting The Cassettes - Canon imageRUNNER 2270 Service Manual

Chapter 2
switch for 3 sec or more.
2. Go through the instructions for the shut-
down sequence shown on the display so
that the main power switch may be turned
off.
3. Turn off the main power switch.

2.2.6 Stirring Toner

1) Enter the Service Mode. (Press "*" first,
and "2" and "8" at the same time, and
then "*.")
2) Select COPIER >FUNCTION >
INSTALL> TONER-S.
3) Press the OK key.
- Toner stirring time is approx. 6 minutes.
After counting
automatically.
- Make the cassette settings before toner
stirring is completed. (See Setting the
Cassettes.)
2.2.7 Setting
Cassettes
1) Press the cassette release button, and
draw out the cassette to the front.
2) Check the paper series that the user is
going to use, and verify whether or not
the paper series selection switch [1] in
the cassette matches that of the user's
selection. If not, change the paper size
series to the appropriate one.
3) Set the paper size selection dial [2] to the
paper size of the paper to be placed.
2-18
0007-5062
up, it stops
the
0007-5065
F-2-40
4) Hold the lever [1] of the side guide plate,
and set the side guide plate to the
appropriate size.
5) Turn the end guide plate [2] to the right
and detach it. Following the instructions
given on the base plate of the cassette,
set the end guide plate to the appropriate
size.