Test The Alarm Package - Optional Equipment - Genie S-60 TraX Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
B-18
Test the Alarm Package -
Optional Equipment
Genie specifications require that this procedure be
performed every 250 hours or quarterly, whichever
comes first.
The alarm package includes:
• Travel alarm
• Descent alarm
• Flashing beacon
Note: The descent alarm is standard equipment on
all models after serial number 15908.
Alarms and a beacon are installed to alert operators
and ground personnel of machine proximity and
motion. The alarm package is installed on the
turntable covers.
Note: The alarms and beacon will operate with the
engine running or not running.
1 Turn the key switch to ground control and pull
out the red Emergency Stop button to the on
position at both the ground and platform
controls.
Result: The flashing beacon should be on and
flashing.
2 Move the function enable/rpm select toggle
switch to either side and activate the boom
toggle switch in the down position, hold for a
moment and then release it.
Result: The descent alarm should sound when
the switch is held down.
3 - 34
3 S-65 and S-65 TRAX: Move the function enable/
4 Turn the key switch to platform control.
5 Press down the foot switch. Move the boom
6 S-65 and S-65 TRAX: Press down the foot
7 Press down the foot switch. Move the drive
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
rpm select toggle switch to either side and
activate the jib boom toggle switch in the down
position, hold for a moment and then release it.
Result: The descent alarm should sound when
the switch is held down.
Result: The flashing beacon should be on
and flashing.
control handle to the down position, hold for a
moment and then release it.
Result: The descent alarm should sound when
the control handle is held down.
switch. Move the jib boom toggle switch to the
down position, hold for a moment and then
release it.
Result: The descent alarm should sound when
the control handle is held down.
control handle off center, hold for a moment and
then release it. Move the drive control handle off
center in the opposite direction, hold for a
moment and then release it.
Result: The travel alarm should sound when the
drive control handle is moved off center in either
direction.
December 2013
Part No. 147753