Genie S-60 TraX Service Manual page 65

December 2013
15 Install the track assembly onto the drive hub
adapter while guiding the hub adapter studs into
the sprocket of the track assembly. Install as
many sprocket retaining fasteners as possible
to the hub adapter and torque to specification.
Refer to Section 2, Specifications .
16 Raise the machine, remove the jack stands and
lower the machine.
17 Drive the machine in either direction just until
the remaining sprocket retaining fasteners can
be installed onto the drive hub adapter. Turn the
machine off.
18 Install the remaining sprocket retaining fasteners
to the drive hub adapter and torque to
specification. Refer to Section 2, Specifications .
19 Repeat this procedure for each drive hub.
Part No. 147753
Turntable rotate drive hub
1 Remove the plug located on the side of the hub
2 If necessary, add oil until the oil level is even
3 Apply pipe thread sealant to the plug, and
4 Check the torque of the turntable drive hub
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
and check the oil level.
Result: The oil level should be even with the
bottom of the plug hole.
a drain/fill plug
b mounting fasteners
with the bottom of the plug hole.
install the plug in the drive hub.
mounting fasteners. Refer to Section 2,
Specifications .
3 - 27