Valve Adjustments - Function Manifold - Genie S-60 TraX Service Manual

December 2013
7-2
Valve Adjustments -
Function Manifold
How to Adjust the System
Relief Valve
Note: Perform this procedure with the boom in the
stowed position.
1 Connect a 0 to 5000 psi / 0 to 350 bar pressure
gauge to the port on the function manifold.
PTEST
2 Start the engine from the ground controls.
3 Hold the function enable/rpm select toggle
switch to the high idle position. Activate and
hold the boom retract toggle switch with the
boom fully retracted.
4 Observe the pressure reading on the pressure
gauge. Refer to Section 2, Specifications.
5 Turn the engine off. Use a wrench to hold the
relief valve and remove the cap (item K).
6 Adjust the internal hex socket. Turn it clockwise
to increase the pressure or counterclockwise to
decrease the pressure. Install the relief valve
cap.
Tip-over hazard. Do not adjust
the relief valve higher than
specified.
7 Repeat steps 2 through 5 and recheck relief
valve pressure.
8 Remove the pressure gauge.
Part No. 147753 S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
Section 4 • Repair Procedures
MANIFOLDS
4 - 49