Specifying A Setting For Special Paper - Konica Minolta Bizhub C353 User Manual

6
7
Specify the X and Y sides of the paper, and then touch [OK].
– Touch either [X] or [Y], press the [C] (clear) key to clear the current setting, and then use the keypad
to type in the size.
– To store a paper size of 12 × 18 w (304.8 mm × 457.2 mm), touch [12 × 18 w]. Enter values for "X"
and "Y".
– If a value outside the allowable range is specified, the message "Input error" appears. Type a value
within the allowable range. The allowable range differs depending on the paper sizes.
– If the orientation of the loaded paper does not match the sizes specified for "X" and "Y", "Input
error" appears, even if the values are within the allowable range. In addition, do not enter the same
size for "X" and "Y".
– If the value was incorrectly entered, press the [C] (clear) key in the keypad to erase the value, and
then specify the correct value.
To cancel changes to the settings, touch [Cancel].
8
Touch [OK], and then touch [OK] in the next two screens that appear.
The Basic screen appears again.
Note
The selected size button is programmed with the entered paper size, so that the paper size is available
to be selected again without being typed in. In addition, the size can be changed.
6.2.6

Specifying a setting for special paper

If paper other than plain paper, such as OHP transparencies or special paper, is loaded in a paper tray, be
sure to change the paper type setting for that tray.
The following procedure describes how to specify the setting for special paper loaded into tray 1.
1
In the Basic screen, touch [Paper].
The Paper screen appears.
6-16
Copy paper/originals
C353/C253/C203