Konica Minolta Bizhub C353 User Manual page 135

2
Setting
Group
Offset
Center Staple/Fold
Output Tray
Center Staple & Fold
Staple
Punch
The following procedures describe how to select Finishing settings.
Reminder
The Staple settings are available only if the optional finisher is installed.
The Punch settings are available only if the punch kit is installed on the optional finisher.
2-62
Description
Select this setting to separate the copies of
each page in a multi-page original.
If no finisher or separator is installed
If the sorting conditions are met, printed
copies are fed out and sorted in an alternat-
ing crisscross pattern.
If a finisher or a separator is installed
The copies are fed out and stacked on top of
each other with each set shifted to separate
it.
Select this setting to fold copies. The copies
are bound with staples and fed out. The
copies can also be folded and bound with
staples at the same time, and then fed out.
The "Center Staple/Fold" setting can be
used if the saddle stitcher is installed on op-
tional finisher FS-519.
Select the output tray where the finished copies are to be fed.
Select this setting to fold the printed copies
and bound them with staples before feeding
them out.
The "Center Staple & Fold" setting can be
used if the optional finisher FS-609 is in-
stalled.
Select one of these settings to bind the cop-
ies with a staple in the corner or with two
staples.
Holes are punched (4 holes) in the copies for
filing them.
Basic copy operations
4
3
2
1
1
1
1
1 4
1 2
1 3
4 1
3 1
2 1
1 1
1 4
1 3
1 2
4 1
3 1
2 1
1 1
1
C353/C253/C203