Operation Mode Table; Fip-1.N1 When Power Is Turned On - Dell 2135cn Service Manual

5.2 Operation Mode Table

FIP-1.N1 When Power is Turned On

Step
Possible causative parts:
PHD UNIT (PL4.1.21)
FUSER ASSY (PL6.1.1)
TRANSFER ASSY (PL6.1.7)
DRIVE ASSY SUB (PL7.1.1)
DRIVE ASSY MAIN (PL7.1.2)
Checking the Main Motor
Does the noise arise from the printer?
1
Checked by [Digital Output]-[DO-00] of the [IOT Diag] on the
[Printer] of the diagnosis.
Checking after reseating the PHD UNIT
Reseat the PHD UNIT.
2 Does the noise arise from the printer?
Checked by [Digital Output]-[DO-00] of the [IOT Diag] on the
[Printer] of the diagnosis.
Checking after reseating the TRANSFER ASSY
Reseat the TRANSFER ASSY.
3 Does the noise arise from the printer?
Checked by [Digital Output]-[DO-00] of the [IOT Diag] on the
[Printer] of the diagnosis.
Checking after reseating the DRIVE ASSY MAIN
Reseat the DRIVE ASSY MAIN.
4 Does the noise arise from the printer?
Checked by [Digital Output]-[DO-00] of the [IOT Diag] on the
[Printer] of the diagnosis.
Checking the Sub Motor
Does the noise arise from the printer?
5
Checked by [Digital Output]-[DO-05] of the [IOT Diag] on the
[Printer] of the diagnosis.
Checking after reseating the PHD UNIT
Reseat the PHD UNIT.
6 Does the noise arise from the printer?
Checked by [Digital Output]-[DO-05] of the [IOT Diag] on the
[Printer] of the diagnosis.
Checking after reseating the FUSER ASSY
Reseat the FUSER ASSY.
Warning: Start the operation after the FUSER ASSY has
7 cooled down.
Does the noise arise from the printer?
Checked by [Digital Output]-[DO-05] of the [IOT Diag] on the
[Printer] of the diagnosis.
Version 1 2008.02.01
Check
1 - 417
Chapter 1 Troubleshooting
Remedy
Yes
Go to step 2. Go to step 5.
Go to step 3. End of work.
Go to step 4. End of work.
Try replacing the
PHD UNIT (refer
to Removal 3/
Replacement 57),
TRANSFER
ASSY (refer to
Removal 48/ End of work.
Replacement 12)
and DRIVE ASSY
MAIN (refer to
Removal 33/
Replacement 27)
one after another.
Check the
Go to step 6. installation
situation of printer.
Go to step 7. End of work.
Go to step 8. End of work.
No